Search

Forum


Print a map
You are not authorized to post a reply.
New Member
Posts: New Member

--
2011-11-07 18:23
    Hello, I made plans with Capture. I now want to print these plans. I click the little key on the bottom right of the image. I click save the image. If I see my plan resolution is very bad. It is impossinble read the numbers of circuits and "leefilter". If I enlarge the image to save an image of good resolution I have only one part of the image. How to save the image in a good resolution? The goal is then to print these images in a copy center. My version is the version of Capture "LT light" and my Hydrasky is connected with the PC. Thank you. Sorry for bad English, it's a Google translation, I am French.
    Staff Member
    Posts:2016 Staff Member

    --
    2011-11-08 07:37
    • Accepted Answer
    Dear puce_84,

    Instead of printing from a simulator view (one of the three), you want to create a new plot in the Design tab, just below where the reports are. Plots print directly to printer!

    Technical Director
    Capture Visualisation AB
    New Member
    Posts: New Member

    --
    2011-11-08 10:28
    • Accepted Answer
    It does not work! I click "right" on plot. I click on "add new block". "New plot" appears below the folder "plot". I double click on "New plot". (or I click "right" and "open"). A window opens. A blank page appears at the center of this window. The plan does not appear. I tried to change the "page setup" it makes no difference. I tried to print, the page is blank. Can you tell me in detail how to do? Can you tell me or find this information in the documentation? Can you answer with short sentences and simple? That's the translation is made ​​by Google. Thank you very much for your help.
    Staff Member
    Posts:2016 Staff Member

    --
    2011-11-08 10:44
    • Accepted Answer
    Hi puce_84,

    You are right, the plan starts as a blank piece of paper. Just right click again in that window to add different types of views and information!

    Technical Director
    Capture Visualisation AB
    New Member
    Posts: New Member

    --
    2011-11-08 11:18
    • Accepted Answer
    formidable ! Ca marche ! Merci.
    Basic Member
    Posts:27 Basic Member

    --
    2011-11-18 15:59
    • Accepted Answer
    Bonjour je suis en france, si je peux me rendre utile.
    You are not authorized to post a reply.