Register
Search

Forum

Forums Community Support Other
Joining Truss
You are not authorized to post a reply.

Mike M
New Member
Posts: New Member

--
2007-10-30 15:56
    Hello,

    Is ther any way to join truss pieces ? This was fairly simple in Capture3, not sure how to do it in Capture 2005.

    Regards
    Mike.

    Good to see ljb in the forums !

    Lars Wernlund
    Staff Member
    Posts:2016 Staff Member

    --
    2007-10-31 23:25
    Hi Mike,

    In Capture 3.0, snapping was a mode that you had to turn on. In Capture 2005 it is always on, but activated by a short time delay. When holding a truss item close to another, the snapping activates and shows you in a purple color where it will snap. If you wish to avoid that happening you can press the Escape key when the purple highlight shows.

    Regards,
    Lars Wernlund
    Technical Director
    Capture Visualisation AB
    You are not authorized to post a reply.