Register
Search

Forum

Forums Community Support Issues
MAC250+ not moving
You are not authorized to post a reply.

Mark Mealy
New Member
Posts: New Member

--
2012-04-04 22:32
    I just finished a show last week using MagicQ. Yesterday I bought Capture and created my stage in it. Then I ranthe show while connected to Capture. Everything appears to work except that the 4 MAC 250's do not move. The dimmers on the 250s open and close and all the PAR cans work fine. I'm running both programs on a Dell laptop. Ideas?

    Colin Wood
    Veteran Member
    Posts:157 Veteran Member

    --
    2012-04-05 14:14
    Have you made sure that your Macs are set to the same mode in Capture, that they are patched to in Magic Q? This can be changed from the design tab in the bottom right window after selecting the fixtures in question.

    If everything else is ok, it's more than likely that's the issue I reckon.

    Mark Mealy
    New Member
    Posts: New Member

    --
    2012-04-05 22:03
    I tried the other mode 4 (there were two) and it worked fine after that. Thanks!
    You are not authorized to post a reply.