Here's a slight difficulty I've come across.
I built a rig, and then found out that all the fixtures needed to be rotated by 180 degrees. "No problem" I thought, "I'll just select them all and type in "180" into the Y rotation field. Except it seems that Capture will only accept values up to 90º, after that, it "starts over" again, so a rotation value of 180º gives the same result as a value of 0º. The only way around this that I've found is to individually zoom in, individually select each fixture, and use the rotation handle to manually rotate the fixture around the way I need it to go. Which, on my rig of 186 fixtures, is going to take a loooooong time.
Is there any other workaround that would be....faster?